pseudowire-class command
Hi,
I used IOU to setup my CCIE-SP topology with IOS (i86bi-linux-l3-adventerprisek9-15.2.4M1), but when I need to configure (preferred-path) under (pseudowire-class) I did not found.
Any idea about which IOS support this command.
R1(config)#pseudowire-class TES
R1(config-pw-class)#en
R1(config-pw-class)#encapsulation mp
R1(config-pw-class)#encapsulation mpls
R1(config-pw-class)#
R1(config-pw-class)#
R1(config-pw-class)#?
Pseudowire-class configuration commands:
default Set a command to its defaults
encapsulation Data encapsulation method
exit Exit from Pseudowire-class configuration mode
interworking Interworking options for pseudowire
no Negate a command or set its defaults
protocol Signaling protocol to use
status Enable pseudowire status extensions in label advertisement and
label notification messages. This is not advised unless your
peer router also supports this functionality as it may lead to
premature enabling of the dataplane on that peer.
I used IOU to setup my CCIE-SP topology with IOS (i86bi-linux-l3-adventerprisek9-15.2.4M1), but when I need to configure (preferred-path) under (pseudowire-class) I did not found.
Any idea about which IOS support this command.
R1(config)#pseudowire-class TES
R1(config-pw-class)#en
R1(config-pw-class)#encapsulation mp
R1(config-pw-class)#encapsulation mpls
R1(config-pw-class)#
R1(config-pw-class)#
R1(config-pw-class)#?
Pseudowire-class configuration commands:
default Set a command to its defaults
encapsulation Data encapsulation method
exit Exit from Pseudowire-class configuration mode
interworking Interworking options for pseudowire
no Negate a command or set its defaults
protocol Signaling protocol to use
status Enable pseudowire status extensions in label advertisement and
label notification messages. This is not advised unless your
peer router also supports this functionality as it may lead to
premature enabling of the dataplane on that peer.
Comments
-
Jackace
Member Posts: 335
I have 4 different IOU versions and the only one that has that option is:
Cisco IOS Software, Linux Software (I86BI_LINUX-P-M), Experimental Version 15.0(20121031:154527) [dstivers-oct25-2012-golden_spike 102]
I'm not sure if the command works, but it is an option. All the other versions including the newest 15.4 do not even give the option.