Options
EIGRP Secondary Address interesting behaviour
We all know that EIGRP can't form adjacencies over secondary addresses, as the primary ones will take over . However, what will happen when you have a config like this:
R1
R2
The result of show ip eigrp nei:
So, R1 has no active adjacencies but R2 thinks it has. Cool huh? Came across this one while preparing for my TSHOOT and just thought I'd share.
R1
interface FastEthernet0/0 ip address 192.168.1.5 255.255.255.252 duplex auto speed auto router eigrp 1 network 192.168.1.4 0.0.0.3 no auto-summary
R2
interface FastEthernet0/0 ip address 192.168.1.6 255.255.255.252 secondary ip address 172.16.0.1 255.255.255.0 duplex auto speed auto router eigrp 1 network 192.168.1.4 0.0.0.3 no auto-summary
The result of show ip eigrp nei:
R1#show ip eigrp nei
IP-EIGRP neighbors for process 1
R1#
R2#show ip eigrp nei
IP-EIGRP neighbors for process 1
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
0 192.168.1.5 Fa0/0 12 00:01:07 1 5000 2 0
So, R1 has no active adjacencies but R2 thinks it has. Cool huh? Came across this one while preparing for my TSHOOT and just thought I'd share.
Comments
-
Options
TechGuru80
Member Posts: 1,539 ■■■■■■□□□□
Quite interesting...a bunch of error messages showing 172 is not on the same subnet on R1 after trying it out. -
Optionsfredrikjj
Member Posts: 879
The key thing to look for is the "Q count" in the eigrp neighbor output. It basically says that EIGRP has messages that it hasn't received acknowledgement for. Some kind of underlying transport problem. Since it's 2 in this case it should give you a clue at least that something isn't right.