Ios-xr ldp
up2thetime
Member Posts: 154
Hey everyone,
Was looking for a little help with LDP on IOS-XRv. I have two routers connected via their Gi0/0/0/0 interfaces. XR1 connects directly to XR2. They are able to establish an OSPF Adjacency and pass routes to each other. The problem is, LDP neighbours will not form. I followed the configuration in the IOS-XR Fundamentals Guide:
configure terminal
mpls ldp
router-id Loopback1
interface Gi0/0/0/0
commit
That configuration has been applied on both routers. I know multicasts are reaching each other due to OSPF establishing, however I am not sure why the won't become LDP neighbours. I also tried the auto-cofigure method mentioned in the guide.
The OSPF config is as follows:
router ospf 1
router-id 1.1.1.1 and 2.2.2.2 (for XR2)
area 0
interface Loopback 1
network point-to-point
interface Gi0/0/0/0
network point-to-point
I also tried removing the point-to-point OSPF interface configuration, but that still did not work.
Any ideas?
Thanks!
Was looking for a little help with LDP on IOS-XRv. I have two routers connected via their Gi0/0/0/0 interfaces. XR1 connects directly to XR2. They are able to establish an OSPF Adjacency and pass routes to each other. The problem is, LDP neighbours will not form. I followed the configuration in the IOS-XR Fundamentals Guide:
configure terminal
mpls ldp
router-id Loopback1
interface Gi0/0/0/0
commit
That configuration has been applied on both routers. I know multicasts are reaching each other due to OSPF establishing, however I am not sure why the won't become LDP neighbours. I also tried the auto-cofigure method mentioned in the guide.
The OSPF config is as follows:
router ospf 1
router-id 1.1.1.1 and 2.2.2.2 (for XR2)
area 0
interface Loopback 1
network point-to-point
interface Gi0/0/0/0
network point-to-point
I also tried removing the point-to-point OSPF interface configuration, but that still did not work.
Any ideas?
Thanks!
Comments
-
up2thetime Member Posts: 154That's the output of show mpls ldp discovery and show mpls ldp interface?
Thanks for pointing out the discovery command! Found out there was no route to the neighbour router-id. Routing issue.
Thanks again.