Options

cisco switch 2950 - trunk port config issue

cheavcheav Registered Users Posts: 2 ■□□□□□□□□□
in CCNP
hi all, i wanted to configure int f0/1 to be a trunk port, and have done so in conf t. but as you can see below:
Switch#show run int f0/1
Building configuration...
Current configuration : 56 bytes
!
interface FastEthernet0/1
switchport mode trunk
end
Switch#sho int trunk
Switch#

it does not seem to work; "sho int trunk" shows nothing. any help is greatly appreciated.
· Share on FacebookShare on Twitter

Comments

  • Options
    theodoxatheodoxa Member Posts: 1,340 ■■■■□□□□□□
    Is Fa0/1 Up/Up?
    R&S: CCENT → CCNA → CCNP → CCIE [ ]
    Security: CCNA [ ]
    Virtualization: VCA-DCV [ ]
    · Share on FacebookShare on Twitter
  • Options
    nman99nman99 Member Posts: 35 ■■□□□□□□□□
    Ya, after actually adding a connection and getting the interface up/up like theodoxa said,

    Switch#show int trunk
    Port Mode Encapsulation Status Native vlan
    Fa0/1 on 802.1q trunking 1


    Port Vlans allowed on trunk
    Fa0/1 1-1005


    Port Vlans allowed and active in management domain
    Fa0/1 1


    Port Vlans in spanning tree forwarding state and not pruned
    Fa0/1 none
    · Share on FacebookShare on Twitter
  • Options
    cheavcheav Registered Users Posts: 2 ■□□□□□□□□□
    thank you theodoxa and nman99, i connected a device to that port making it live, and i see the trunk now. THANK YOU!!
    · Share on FacebookShare on Twitter
Sign In or Register to comment.