Options
Setting up a new wireless controller...
ptlinva
Member Posts: 125
Hi Everyone,
I setup my 1st wireless controller from scratch. I followed the video at...
https://www.youtube.com/watch?v=0ckpts0rvnA
I did have an issue where I could get my APs to find the WLC but was able to console into them and set the IP addresses and it came up fine.
I'm able to connect to the SSID and everything seems great... EXCEPT...
I'm having a routing issue on my router. I can ping the outside world from the router. However, if I ping with a "source", the pings fails. For example, if I type...
ping 4.2.2.2 source 172.16.1.1
it fails when I add the source parameter on the ping command.
Any suggestions on troubleshooting a routing issue? All routes are "connected" routes except for the one static gateway of last resort.
Thanks in advance for your time and consideration.
Your friend,
Paul
I setup my 1st wireless controller from scratch. I followed the video at...
https://www.youtube.com/watch?v=0ckpts0rvnA
I did have an issue where I could get my APs to find the WLC but was able to console into them and set the IP addresses and it came up fine.
I'm able to connect to the SSID and everything seems great... EXCEPT...
I'm having a routing issue on my router. I can ping the outside world from the router. However, if I ping with a "source", the pings fails. For example, if I type...
ping 4.2.2.2 source 172.16.1.1
it fails when I add the source parameter on the ping command.
Any suggestions on troubleshooting a routing issue? All routes are "connected" routes except for the one static gateway of last resort.
Thanks in advance for your time and consideration.
Your friend,
Paul
Comments
-
Options
Hondabuff
Member Posts: 667 ■■■□□□□□□□
Hi Everyone,
I setup my 1st wireless controller from scratch. I followed the video at...
https://www.youtube.com/watch?v=0ckpts0rvnA
I did have an issue where I could get my APs to find the WLC but was able to console into them and set the IP addresses and it came up fine.
I'm able to connect to the SSID and everything seems great... EXCEPT...
I'm having a routing issue on my router. I can ping the outside world from the router. However, if I ping with a "source", the pings fails. For example, if I type...
ping 4.2.2.2 source 172.16.1.1
it fails when I add the source parameter on the ping command.
Any suggestions on troubleshooting a routing issue? All routes are "connected" routes except for the one static gateway of last resort.
Thanks in advance for your time and consideration.
Your friend,
Paul
Sounds like a NAT issue on the router.“The problem with quotes on the Internet is that you can’t always be sure of their authenticity.” ~Abraham Lincoln
