ospf problem with packet tracer

mister_417

Hello i config ospf in packet tracer the problem i setting with port router and switch no up port.I download jpg file.

ospf.jpg

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

DCD

From the pic some of the interface are down and one maybe misconfigured. Post the PT file on Dropbox or GDrive or a few show commands would help.

mikeybinec

looks like you're using a straight through R0 to R2 so that needs to be fixed.. Not to throw a side issue in but why are you using /24s on the router to router links?

mister_417

https://drive.google.com/drive/folders/0B8n92lXZp7Etdm9STmNkdDhBUmM

mister_417

Can you write moree detail about question?

mikeybinec

mister_417 wrote: »

https://drive.google.com/drive/folders/0B8n92lXZp7Etdm9STmNkdDhBUmM

Need permission to access this

mikeybinec

mister_417 wrote: »

Can you write moree detail about question?

which question(s)?

mister_417

I permit access.
https://drive.google.com/file/d/0B8n92lXZp7EtX2hGQXdDUFI5M0U/view?usp=sharing

mister_417

post three.

DCD

Like mikeybinec said you have the wrong cable on those routers. Also you should give the routers hostnames. Here are your issues.

Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned YES unset administratively down down
FastEthernet0/1 unassigned YES unset up down
Serial1/0 172.16.5.1 YES manual up up
Serial1/1 unassigned YES unset administratively down down

Router#sh ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 192.168.5.1 YES manual up up
FastEthernet0/1 unassigned YES unset administratively down down
Vlan1 unassigned YES unset administratively down down

The PC don't have Ethernet cards

mister_417

Thanks i check.

rob42

So many issues...

Server does not have an IP Address.

Router 7 does not have an IP Address on Fa0/0

Router 2 has an IP Address on Se1/0 only

Router 0 has an IP Address on Fa0/1 only

Router 0 is connected to Router 2 with a Straight-through cable

RID has only been set on one of the Routers

that's just for starters...

I'd recommend that you sort out the basic configuration issues first, then re-post the .pkt file

mikeybinec

Hmmm. Wait a minute here. Are we doing somebody's homework here?

rob42

mikeybinec wrote: »

Hmmm. Wait a minute here. Are we doing somebody's homework here?

I had the same thought...

But, for me, I'm treating it as a personal challenge and part of my CCENT studies as it looks like a good exercise in troubleshooting. I'm sure that I can learn much from sorting this out and making it work.

b.t.w, does anyone know of a good resource where I can find troubleshooting challenges? I'm aware of Wedell Odom's blog [http://blog.certskills.com] but I don't have any others.

mister_417

I change setting first part work because second problem ping doesn t work Router 4-6 Router 9-7 can you tell me why is problem?
https://drive.google.com/drive/folders/0B8n92lXZp7EtQ00yUlFEcnBlLXc password win rar 321