DNS monitoring

Another question about mspress book, chapter 6 says 'to find out which AD partition is used to store data for a particular DNS zone, you can either check the DNS zone properties in the DNS console or use the dnscmd /zoneinfo command.'

Where does this show up in zone properties in dns console, can't find it anywhere.

If i use dnscmd /zoneinfo all it has for directory partition is 'AD-legacy'

Find more posts tagged with

Comments

Mikdilly

Found it.

Mikdilly

What are the effects of installing DNS thru Add/Remove Programs as opposed to Manage Server Roles? Thought it was described in the book but can't find it.

fluk3d

Mikdilly wrote: »

What are the effects of installing DNS thru Add/Remove Programs as opposed to Manage Server Roles? Thought it was described in the book but can't find it.

Don't quote me on this but, I'm pretty sure if you use the add role, it will guide you through a wizard which will help you setup the dns service. If you just use add/remove you are just installing the service, and it will be up to you to configure the rest manually.

dynamik

fluk3d wrote: »

Don't quote me on this but, I'm pretty sure if you use the add role, it will guide you through a wizard which will help you setup the dns service. If you just use add/remove you are just installing the service, and it will be up to you to configure the rest manually.

Sorry, I couldn't resist

I believe that is correct though. To the OP, when it doubt, give it a try

dales

Yep, add/remove dns, just installs the service (so will act as a caching only server) and adding the role will also install the service and then start a zone creation wizardy thing.

Mikdilly

Think I found the "restriction" I was looking for, if dns is installed using Windows Components, a default restriction for zone transfers is limited to the name servers configured on the Name Servers tab. If it's installed using server roles, zone transfers are completely disabled by default.

One other question, if you're using dnscmd with /zonechangedirectorypartition to change directory partitions, the book lists 3 options /legacy, /forest, and /domain. Is there one to change to a custom directory application partition?