Management IP address not accepted by ESXi

OK, someone explain this to me: I have ESXi 3.5 U3 running on and Intel mobo server with a 100/1000 Pro NICs. I am configuring the IP address of the ESXi management interface on the server's Direct Console UI. The UI refuses to accept the IP address 192.168.3.* (with * being any value from 1 to 254). It will take 192.168.0.*, 192.168.1.*, 192.168.2.*, 192.168.4.*, ect., but it does not like 3 as the value in the last octet of the network on any of them. And the netmask is /24.

Anyone have an idea why ESXi would refuse a perfectly valid IP address for its management interface? I haven't yet tried upgrading to U4 to see if this "problem" is fixed by it.

Find more posts tagged with

Comments

astorrs

Sounds like it might be assigned to another interface perhaps?

jibbajabba

astorrs wrote: »

Sounds like it might be assigned to another interface perhaps?

I think he he meant he cannot use the whole /24 range.

I have never seen this before ...

1. Have you tried adding an IP it accepts and then simply add another 192.168.3 management port via the vi client ?

2. Tried to enable SSH and configure the v-switch for the management via command line ?

blargoe

Anytime I've had screwy crap like that happen to me I end up blowing away the vswitch and starting over, usually end up getting it to work

JDMurray

OK, I finally got back to this problem. I upgraded my ESXi 3.5.0 server from U3 to U4 and now the .3 octet is accepted no problem. It looks like a U3 thing.

astorrs

JDMurray wrote: »

OK, I finally got back to this problem. I upgraded my ESXi 3.5.0 server from U3 to U4 and now the .3 octet is accepted no problem. It looks like a U3 thing.

Bet you .4 doesn't work now.

JDMurray

astorrs wrote: »

Bet you .4 doesn't work now.

HA! It does work, Mr. Smarty Pants!

Actually, I ended up using .4 when .3 didn't work and I've stuck with it.

jibbajabba

JDMurray wrote: »

HA! It does work, Mr. Smarty Pants!

Actually, I ended up using .4 when .3 didn't work and I've stuck with it.

So a lot of noise for what ? NOTHING

johnsmith12709

Lot of noise is producing in it.....
...........

Claymoore

This is a complete guess (and irrelevant since you have worked around it), but it's possible VMWare uses .3 for some mystical interal feature and thus won't accept it on the management interface. VMWare's corporate overlord EMC uses 192.168.1.x and .2.x for internal addressing in some of their IP storage products and we had to re-address our backup network to avoid complications with the SAN. .3 is next in line, so it's possible VMWare was doing the same thing.