Basic ASA q from non ccsp student

Hello ASA gurus

I was looking through an ASA config at work this week, and it seems to use a single set of inspection rules for all interfaces by default. I'm I interpreting the config correctly?

I've really only changed a few access lists and NAT rules through the ASDM before (our main fw is not an ASA). Whats caused me to look into this was the fact that I couldn't ping anything (and so thought I had total loss of connectivity) I looked through the running config and noticed the inspect rules and noticed there was no entry for icmp, so I added that and everything was good.

Find more posts tagged with

Comments

Ahriakin

By default there is a global policy that applies to all traffic, and yup you need to add ICMP inspection manually (I'd add ICMP ERROR too for tracing). You can create and apply a distinct policy to each interface if you wish, it will override any matching settings in the global policy.

creamy_stew

Cool, thanks Ahriakin!

The ASAs seem pretty nice, and the ASDM actually seems usable unlike the SDM.

shednik

creamy_stew wrote: »

Cool, thanks Ahriakin!

The ASAs seem pretty nice, and the ASDM actually seems usable unlike the SDM.

It has its moments though don't you worry

mikearama

Ahriakin wrote: »

By default there is a global policy that applies to all traffic, and yup you need to add ICMP inspection manually (I'd add ICMP ERROR too for tracing). You can create and apply a distinct policy to each interface if you wish, it will override any matching settings in the global policy.

Ahriakin, can I ask a follow up? I don't understand how adding a check to the ICMP ERROR box aids in tracing. Can I get you to elaborate? This sounds interesting.

Thanks,
Mike

kryolla

it might have something to do with time exceeded and port unreachable

Ahriakin

ICMP Error messages include the original IP header and usually the first 64bytes of the packet that elicited the failure response, inspecting ICMP error allows the ASA to use the details in that original packet to decide if the reply packet is really a stateful reply (it also allows NAT fixups to be performed if need be). A classic example is in a trace as the TTLs expire the intermediate routers will respond with a packet sourced from their own address, but since they were not the target they do not match a flow and are dropped, with error inspection enabled the ASA can see from the embedded packet data that it should be allowed.