Help with Dynamic Nat / Overload

Hello all;

Im doing a lab and got in a bind..

Here is what I currently have for NAT -

ip nat pool natpoolisp 192.168.100.11 192.168.100.20 netmask 255.255.255.0
ip nat inside source list NAT pool natpoolisp overload
ip nat inside source static 10.10.0.1 192.168.100.1
ip classless
ip route 192.168.2.0 255.255.255.252 192.168.1.6
ip route 172.16.4.0 255.255.255.0 192.168.1.6
ip route 172.16.15.0 255.255.255.0 192.168.1.6

Now my inside FA0/0 interface is 10.10.0.1..

I can ping FA0/0 from my local, 10.10.0.11 host, and it works fine. I can ping the inside global, and it works.

I can not ping 192.168.100.1 or 10.10.0.1 from outside the 10 network.

IE; I can not ping it from R2 which is connected to R1(Nat Router) via Frame Relay.

I have FA0/0 as Ip nat inside, and s0/1/0 as ip nat outside.

Any help is appreciated..

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

techimadhu

What do you have in your access list?
which interface have you marked as ip nat inside and ip nat outiside.
Also give the show ip interfaces brief of your nat router?

bigheadx

I have my FA0/0 on my ISP(Nat Router) as the IP NAT INSIDE,
and I have the S0/1/0 as the IP NAT OUTSIDE

ip access-list extended NAT
permit ip 10.10.0.0 0.0.255.255 any

Interface IP-Address OK? Method Status Protocol

FastEthernet0/0 10.10.0.1 YES manual up up

FastEthernet0/1 unassigned YES manual administratively down down

Serial0/1/0 192.168.1.5 YES manual up up

Serial0/1/1 unassigned YES manual administratively down down

Vlan1 unassigned YES manual administratively down down

bigheadx

My Topo looks like this

Host < -- > ISP(ROUTER) < -- > Sydney(Router) < -- >Auckland (ROUTER) < -- > Host |
Host

bigheadx

Nvm I figured it out :P

hermeszdata

bigheadx wrote: »

Nvm I figured it out :P

And what was the slution?

John