Help with PT please. feeling not too smart !!!

Hello everyone,

Set-up basic configuration on a 2590-24 switch using Packet Tracer.

I am trying to telnet into the switch using PC2, but can not. The protocol status for VLAN 1 = down ---- not sure why.

Here's the running-conf:

Vlan1 192.168.1.5 YES manual up down

S1#show running-config
Building configuration...
Current configuration : 1687 bytes
!
version 12.1
no service timestamps log datetime msec
no service timestamps debug datetime msec
no service password-encryption
!
hostname S1
!
enable password cisco
!
!
!
interface FastEthernet0/1
duplex full
speed 100

cut
!
interface FastEthernet0/24
duplex full
speed 100
!
interface Vlan1
ip address 192.168.1.5 255.255.255.0
!
ip default-gateway 192.168.1.1
!
!
line con 0
password cisco
!
line vty 0 4
password remote
login
transport input telnet
line vty 5 15
password remote
login
transport input telnet
!
!
end

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

BrandonX

Set-up is very basic:

PC1 connect to the switch console port.

PC2 connect to the switch fe 0/1 port using a straight-Through cable.

VAHokie56

do a sh ip int brief on the switch . Is the f0/1 port up?

BrandonX

VAHokie56 wrote: »

do a sh ip int brief on the switch . Is the f0/1 port up?

S1#show ip int br
Interface IP-Address OK? Method Status Protocol

FastEthernet0/1 unassigned YES manual down down

VAHokie56

the vlan is down because a host has not come up in it yet. Trouble shoot the connection between the host and the switch...I would maybe start by removing my hard coded speed & duplex and see where that takes you

BrandonX

Thank you ... That help a lot. The speed setting couldn’t be match with from the PC2 within PT. At lease I don’t know how.