Sdm

So, I have bin labing, going through CBT nuggets, train signal, ect ect. I can not find the SDM on cisco's website anywhere, populer rumor is that it is not part of the ASA line, not available for the standard router. Can anyone confirm or deny?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

JasminLandry

You can alway use CCP. Its the "new" SDM.

DCD

SDM was replace by CCP like JasminLandry said a few years back. Current curriculum use the CCP.

jschreck

Thanks, what does CCP stand for so I can find it.

Hatch1921

Here you go.

Cisco Configuration Professional - Products & Services - Cisco Systems

You can use it with GNS3 if you want to give it a shot... Youtube GNS3 with CCP for the setup instructions...

Hatch

theodoxa

SDM was dropped [from what I can tell] on the new ICND1 and ICND2. The old ICND1 [which you can take until September] still lists configuring DHCP and NAT via SDM as an exam objective. Personally, I have never been able to get SDM fully working. It's a Java issue as some of the functionality is not usable with a current version of Java. I tried installing the Java version that was specifically listed as compatible, but no luck. Personally, I'd rather config it from the CLI anyways. DHCP on the CLI is easy. Basic SNAT and DNAT aren't too difficult either.

RouteMyPacket

I never once ran into or even used SDM/CCP during my CCNA. Not sure why they mention it?

theodoxa

RouteMyPacket wrote: »

I never once ran into or even used SDM/CCP during my CCNA. Not sure why they mention it?

I've seen a number of other people indicate the same thing. Perhaps, it has been unofficially removed (still on the objectives, but no longer covered on the actual exam).