Is L3 Etherchannel possible in Packet Tracer?

mjstonemjstone Registered Users Posts: 1 ■□□□□□□□□□
Can anybody tell me if Layer 3 Etherchannel is at all possible on the 3560 multi-layer switch in Packet Tracer?

It does not accept the "no switchport" command, to set it to Layer 3 mode.

Heres the output I get:
Switch(config)#int port-channel 1
Switch(config-if)#no switchport
% Incomplete command.
Switch(config-if)#no switchport ?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
native Set trunking native characteristics when interface is in
trunking mode
nonegotiate Device will not engage in negotiation protocol on this
interface
port-security Security related command
priority Set appliance 802.1p priority
trunk Set trunking characteristics of the interface
voice Voice appliance attributes
Switch(config-if)#?
arp Set arp type (arpa, probe, snap) or timeout
bandwidth Set bandwidth informational parameter
cdp Global CDP configuration subcommands
delay Specify interface throughput delay
description Interface specific description
duplex Configure duplex operation.
exit Exit from interface configuration mode
hold-queue Set hold queue depth
no Negate a command or set its defaults
service-policy Configure QoS Service Policy
shutdown Shutdown the selected interface
spanning-tree Spanning Tree Subsystem
speed Configure speed operation.
standby HSRP interface configuration commands
storm-control storm configuration
switchport Set switching mode characteristics
tx-ring-limit Configure PA level transmit ring limit
Switch(config-if)#


There does not seem to be the capability to set an ip address for the port-channel interface at all.

Am I missing something simple here or is this simply not supported in Packet Tracer?

Packet Tracer v6.0.1.0011

Comments

Sign In or Register to comment.