How to see Traffic rate QoS Classes.

avc1984

Hi, i have one EX4200. I configured CoS and shaping for the diferents queue's but im not able to find the command that shows the rate at one given moment.

with show int xxxx detail i can see the total packets trasmited from every class but not the actual speed.

Can you help me out?

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

tomtom1

show interfaces xxx extensive shows the input and output packets? That what you want?

avc1984

tomtom1 wrote: »

show interfaces xxx extensive shows the input and output packets? That what you want?

thanks for answering. No, what i need is see how much traffic in bits/seg or bytes/seg for the 7 diferent CoS configured in the switch (best-effort, video, etc). With show int xxx detail or extensive i see the total input and output packets for the different classes configured, but not the speed in a given moment.

networknubbin

Are you looking for:

show interfaces queue <interface>

?

That'll give you current traffic:

> show interfaces queue fe-0/0/6
Physical interface: fe-0/0/6, Enabled, Physical link is Up
Interface index: 140, SNMP ifIndex: 517
Forwarding classes: 8 supported, 4 in use
Egress queues: 8 supported, 4 in use
Queue: 0, Forwarding classes: best-effort
Queued:
Packets : 1604523 1 pps
Bytes : 190626779 1200 bps
Transmitted:
Packets : 1604523 1 pps
Bytes : 190626779 1200 bps
Tail-dropped packets : 0 0 pps
RED-dropped packets : 0 0 pps
Low : 0 0 pps
Medium-low : 0 0 pps
Medium-high : 0 0 pps
High : 0 0 pps
RED-dropped bytes : 0 0 bps
Low : 0 0 bps
Medium-low : 0 0 bps
Medium-high : 0 0 bps
High : 0 0 bps

snadam

I think that show interfaces queue <interface> is going to be your closest match, unfortunately. Recently when working on a project that involved CoS, I had to rely on packet counters and monitoring tools like iperf and prtg to ensure my queues were working correctly. I remember looking for a similar command and having no luck. I hope I'm wrong and someone chimes in with the command, but I wasn't able to find anything.