USB disabled in BIOS. How can I turn back on without a keyboard?

I have a friends PC who turned off all his USB ports in the BIOS (HP Pavilion S5-1400) and now he can't do anything. His PC wasn't working, which is why he was messing around with it. Is there a way to reset that thing by pulling batteries, jumpers on the motherboard, etc., etc?

Find more posts tagged with

Comments

digitheads

either pull the battery and let the CMOS die, or us a jumper to reset it to factory, then start over.

cyberguypr

Reset CMOS via jumpers: HP and Compaq Desktop PCs - Motherboard Specifications, IPISB-CU (Carmel2) | HP® Support

Mow

Does he possibly have any kind of remote access software installed (TeamViewer, etc)? Did he happen to enable Remote Desktop?

Rainmaker51

No, unfortunately he did not. Even then, the computer only got so far on bootup. Loaded with Malware
Thanks everyone.

Rainmaker51

Well, I tried pulling the battery, waited more than a few minutes, popped it back in, and it said "Time and Date Not Set", but still no keyboard function.

Mow

How about a USB expansion?

Rosewill RC-505 - 2-Port USB 3.0 PCI Express Card - Newegg.com

markulous

Try the jumper settings that cyberguy posted in here. That should do it.

Plantwiz

cyberguypr wrote: »

Reset CMOS via jumpers: HP and Compaq Desktop PCs - Motherboard Specifications, IPISB-CU (Carmel2) | HP®*Support

This is about as back-to-basics as one can get. I trust you are having difficulty with the KB because you are using a USB KB? Do you have PS2 ports on there? Try a standard KB and the various DEL, F1, F8 or which ever BIOS entry key pops up for your version of HP.

EDIT - another thought, you may have to pull the HDD and scan it outside of the HP, clean it up, reinsert the HDD and try the jumper reset. This should clear up your malware and enable your USB as it should permit you to enter BIOS.

thomas_

To piggyback off of Plantwiz, you may need to get a wired keyboard instead of a wireless keyboard if that is what you're using. I couldn't boot my computer to the BIOS with my wireless keyboard and had to buy a wired one. Both were USB keyboards.

Rainmaker51

Even though the HP documentation was incorrect, after searching through the forums there, someone had posted the correct jumper settings. Thanks to you and everyone with helpful suggestions.

Plantwiz

Thank you for following up to let us know you are all set and that the jumper reset worked for you!

digitheads

@Mow - remote control software will not work at the BIOS level. even if they could boot, and access the system remotely it would not allow you to manipulate the CMOS to re-enable USB ports.

Mow

Yeah, I caught that (when you mentioned it was BIOS) and am now ashamed. I guess I didn't read the OP very closely.