Cisco router and 1 switch !

I have 3 Cisco 1800 series router, 2- 2800 series router, and 1- 2960 switch. i was wonder can i use all of this for practice on my lab. Any ideas for me to get more equipment for advance lab. I just want to focus on CCNA right now.

Thanks all you !!!

Find more posts tagged with

Comments

Nans

With the very less information i know a layer 3 switch 3550 or 3560 will be really helpful during inter-VLAN routing practise also people say this is the best one to have since you are going to see it more often in real world.

Its just my opinion I am a starter hope experts correct me if I am wrong
Regards

Magmadragoon

You should be fine for the CCNA with that setup. With your lab, you can learn how to configure a switch, configure a router, do routing protocols, and do basic security with that setup.

koz24

You will need more than 1 switch for Spanning Tree Protocol labs in ICND2. Ideally you will want 3-4 switches. Like Nans said you should try to get a 3560 so you can practice multi-layer switching. 5 routers is more than enough.

instajohn

Thanks Nans.

Nans wrote: »

With the very less information i know a layer 3 switch 3550 or 3560 will be really helpful during inter-VLAN routing practise also people say this is the best one to have since you are going to see it more often in real world.

Its just my opinion I am a starter hope experts correct me if I am wrong
Regards

instajohn

Thanks. Magmadragoon.

Magmadragoon wrote: »

You should be fine for the CCNA with that setup. With your lab, you can learn how to configure a switch, configure a router, do routing protocols, and do basic security with that setup.

instajohn

Thanks. Koz24

koz24 wrote: »

You will need more than 1 switch for Spanning Tree Protocol labs in ICND2. Ideally you will want 3-4 switches. Like Nans said you should try to get a 3560 so you can practice multi-layer switching. 5 routers is more than enough.