Here's what I am studying today...

mikeybinecmikeybinec Member Posts: 484 ■■■□□□□□□□
in CCNA & CCENT
This might be an interesting thread for us trainees. (In other words, what are you studying and post it here) Today, I wired up three 2650s in the standard triangle format. (WAN links) The end routers I put loopbacks from different subnets. Then I started EIGRP with no auto summary. It might be hard to see, but the top and middle router has two serial links so there is an equal cost load balancing to the top router's loopbacks. Now, I'm gonna vary the bandwidth on one of the serial interfaces. Then change it back. Then add a fast0/0 link between the end routers and see what the routing table sez about the path to that network. Last, but not least, I wanna check out variances and maximum-paths. I though max-paths were the number of balanced routes in the routing table but ....hmmm not sure

Cisco NetAcad Cuyamaca College
A.S. LAN Management 2010 Grossmont College
B.S. I.T. Management 2013 National University
· Share on FacebookShare on Twitter

Comments

Sign In or Register to comment.