RR and 6PE
Hello,
I was wondering what options do we have to enable RR next-hop resolution for labeled IPv6 routes without creating static routes in inet.3 or inet6.3?
Importing PE loopbacks from inet.0 into inet.3 using rib-groups does not seem to work as it doesn't create the PE IPv4-mapped IPv6 PE /32 routes (i.e. ::ffff:172.30.5.1) in the inet6.3 table.
Turning on LDP everywhere is also not a feasible solution.
Any help/guidance in this would be greatly appreciated!
I was wondering what options do we have to enable RR next-hop resolution for labeled IPv6 routes without creating static routes in inet.3 or inet6.3?
Importing PE loopbacks from inet.0 into inet.3 using rib-groups does not seem to work as it doesn't create the PE IPv4-mapped IPv6 PE /32 routes (i.e. ::ffff:172.30.5.1) in the inet6.3 table.
Turning on LDP everywhere is also not a feasible solution.
Any help/guidance in this would be greatly appreciated!
Comments
-
ccie14023
Member Posts: 183
Try using "install" under the LSP. This is not technically a static route. -
mrahma04
Registered Users Posts: 2 ■□□□□□□□□□
The RR does not have full-mesh RSVP tunnels to all the different PEs.
So do you mean, using the "install" option for the specific 6PE loopbacks/network under some other LSP?