Is my ASA 5505 dead?

Edificer

when I log in through console part, I see this error message:

i2c_read_word_w_wait() error, slot = 0x0, device = 0x64, address = 134 byte count = 2. Reason: I2C_UNPOPULATED_ERROR

This happens a few moments after loading the image. Then the session stops producing output. Has anyone encountered this before, if so, any workaround?

aquilla

Did some quick searching and a couple of sites suggest changing out the CF flash card in the ASA. If the unit still gives the same error with the new card then it looks like a hardware fault.

If you have Cisco TAC support then raise a case with them.