Anyone know how to show interfaces status on EX8200 chassis

I went looking through through the Juniper support page and can't find a configuration guide for this thing. Is there anything similar to the Cisco show ip interface brief so I can see what the ports are labeled as?

Specifically have a EX8200-8XS in slot 0 and 1.

Find more posts tagged with

Comments

networker050184

Show interface terse is the equivalent.

atorven

show interfaces terse?

Legacy User

Hehe, yes sorry I edited my OP before I seen your message. I'm trying to find what the ports would be labeled as for a EX8200-8XS in slot 0 and 1.

Legacy User

This is what I have specifically in slots 0 and 1:

FPC 0 REV 23 710-016837 BB1710312092 EX8200-8XS
CPU
FPC 1 REV 23 710-016837 BB1710312167 EX8200-8XS
CPU

root> show interfaces terse
Interface Admin Link Proto Local Remote
bme0 up up
bme0.32768 up up inet 128.0.0.1/2
128.0.0.4/2
128.0.4.0/2
tnp 0x4
bme0.36862 up up inet 128.0.0.1/2
128.0.0.4/2
129.0.0.1/2
129.0.0.4/2
bme1 up up
bme1.32768 up up tnp 0x4
bme2 up up
bme2.32768 up up tnp 0x4
bme3 up up
bme3.32768 up up tnp 0x4
dsc up up
gre up up
ipip up up
lo0 up up
lsi up up
me0 up down
mtun up up
pimd up up
pime up up
tap up up
vlan up up

root>

Each has 8 ports I don't see the 8 ports for either blade in the show interface terse?

networker050184

They should be 0/0/ and 1/0/ respectively.

As far as it not showing in terse output check this - 8200 8XS Blades - Not Showing Up in Configuration - J-Net Community

Legacy User

Awesome! great call on the link!