Extended Ping

Do I need to know all the options for ccent ?

Router#ping

Protocol [ip]:
Target IP address: 192.168.1.1
Repeat count [5]:
Datagram size [100]:
Timeout in seconds [2]:
Extended commands [n]: y
Source address or interface: 192.168.10.1
Type of service [0]:
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds:
Packet sent with a source address of 192.168.10.1
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 0/7/19 ms

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

koz24

I doubt you need to memorize that level of detail.

pinkiaiii

i think ping -n 10 Cisco Systems, Inc is enough for ccent.

but theres a possibility they would ask for ping from loopback interface-since its not real interface you have to execute it from router ping+enter+smth+smth then source address destination address,i know that was covered in one of the earlier chapters but seemed hard enough to navigate to do it.