Having a Frame Relay brain far*
mikeybinec
Member Posts: 484 ■■■□□□□□□□
in CCNA & CCENT
Yeah, I know FR is out in a couple of months, but I still like to lab it
for jokes. So today I have an FR switch and three endpoints and here's the topo and
one FR switch config:
and then here's one config on the router that has frame-relay routing enabled
ON the config on the bottom, I assign two dlci's to the same interface but my FR switch sez can't do that (two dlcis's)
What am I doing wrong? I thought it was a subinterface thing, but these labs are out of CCNP
Thanks
for jokes. So today I have an FR switch and three endpoints and here's the topo and
one FR switch config:
and then here's one config on the router that has frame-relay routing enabled
ON the config on the bottom, I assign two dlci's to the same interface but my FR switch sez can't do that (two dlcis's)
What am I doing wrong? I thought it was a subinterface thing, but these labs are out of CCNP
Thanks
Cisco NetAcad Cuyamaca College
A.S. LAN Management 2010 Grossmont College
B.S. I.T. Management 2013 National University
A.S. LAN Management 2010 Grossmont College
B.S. I.T. Management 2013 National University
Comments
-
james43026
Member Posts: 303 ■■□□□□□□□□
You know, I'm not seeing anything wrong with that config. Are you doing this on real equipment, or in a simulator or an emulator? Could you post the exact verbage that you receive when you try to do this? Also try entering the encapsulation without the IETF portion.