EIGRP AD question
txn41655
Member Posts: 53 ■■□□□□□□□□
in CCNA & CCENT
Hi I am new,
1. Could anyone tell me if it possible to change the Administrative Distance of a specific EIGRP route ?
I found this but is for all routes at once? :
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#router eigrp 111
Router(config-route)#network 192.168.16.0
Router(config-route)#distance eigrp 55 200
Router(config-route)#end
Router#
2. How could I redistribute a specific static route in EIGRP ?
1. Could anyone tell me if it possible to change the Administrative Distance of a specific EIGRP route ?
I found this but is for all routes at once? :
Router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#router eigrp 111
Router(config-route)#network 192.168.16.0
Router(config-route)#distance eigrp 55 200
Router(config-route)#end
Router#
2. How could I redistribute a specific static route in EIGRP ?
Comments
-
WastedHat Member Posts: 132 ■■■□□□□□□□I imagine changing the AD for different routes is only going to over complicate the configuration, especially if you're doing CCNA level stuff. I'm not sure hows it done or if its possible sorry.
Had a quick look into redistributing static routes, apparently you can use "redistribute static" in EIGRP router config mode or add a network command. I've never done this before so thanks for the lab idea! -
pevangel Member Posts: 342I don't think you can change AD for a specific route, but you can redistribute a specific route using route maps.
-
stunnedsoup Member Posts: 120From what I've read from my Odom book I think you can. "...IOS can be configured to change the AD of a particular routing protocol or even a single route."Cisco: CCENT COLOR=#ff0000]✔[/COLOR CCNA COLOR=#ff0000]✔[/COLOR || MCSE: 70-410 COLOR=#ff0000]✔[/COLOR 70-411 [ ] 74-409 COLOR=#ff0000]✔[/COLOR 70-534 [ ] || VMWare: VCP [ ]