Options
Shutting down s0 question
peter0175
Member Posts: 3 ■□□□□□□□□□
in CCNA & CCENT
I am using the CCNA Virtual Lab e-trainer from Sybex and heres my question.
I have setup s0 and when I issue the sh int s0 command, it says "Serial0 is up, line protocol is up". Now when I go back and enter the shutdown command on s0, the output says, "...Interface Serial0, changed state to administratively down". Now I go back and enter the sh int s0 command, it now shows "Serial0 is down, line protocol is down". Shouldn't it say "Serial0 is administratively down, line protocol is down"?
I have setup s0 and when I issue the sh int s0 command, it says "Serial0 is up, line protocol is up". Now when I go back and enter the shutdown command on s0, the output says, "...Interface Serial0, changed state to administratively down". Now I go back and enter the sh int s0 command, it now shows "Serial0 is down, line protocol is down". Shouldn't it say "Serial0 is administratively down, line protocol is down"?
Comments
-
Optionsjontebond
Member Posts: 6 ■□□□□□□□□□
yes it should!
on the other router, it should say:
down, down