ES 3000-PWR Switch (help)

KGhaleon

I had someone give me this switch which needs to be reconfigured because the IP address and gateway are incorrect. It's an ES 3000-PWR and there is more info here:

http://www.thebarcodewarehouse.co.uk/literature/20060421_85917_6844601a.pdf
(manual)

I've configured switches before, but this one throws me off a bit. It doesn't have a console port(or one that's labeled)...I just see two labeled 25 and 26. Then a serial port with |O|O| written under it. How am I suppose to configure this?

I plugged a rollover cable into both of the available ports on the right-hand side and tried hyperterminal, but I'm not getting any sort of output.



KG

mikej412

Null modem cable.... that was my best guess -- before I found it in section 3.1 of that link.

19200 -- N-8-1 -- no flow control

KGhaleon

Tried a null modem cable with hyperterminal(played with the settings) and still couldn't get any output from the switch. He's going to take it back to the company that sent it to him and have them correct it.

KG