Cannot route between 2 networks using RRAS
I have a Windows 2003 RRAS server with 2 NICs.
It is configured as a router with NAT.
The machines on the internal network can access
anything on the external network but not vice versa.
I already checked the route table and it is set up
properly. Any ideas?
It is configured as a router with NAT.
The machines on the internal network can access
anything on the external network but not vice versa.
I already checked the route table and it is set up
properly. Any ideas?
Comments
-
bighornsheep
Member Posts: 1,506
Do you have both of these servers running NAT on an internal IP from a gateway?
You can not use the same interface for NAT and Routing, the source address will be translated on the remote network and it will not work. I have basically the same setup and my solution was to add a 3rd NIC on each server to use for routing only.Jack of all trades, master of none
