Failed!
Bill Kaster
Member Posts: 94 ■■□□□□□□□□
in CCNA & CCENT
ok, so I failed, but not by much- I got a 794 with my weakest area being implementation and operation. I think I probably did worst in switch configuration. Here are some of my questions (unrelated to the content on my test fyi).
Firstly i know about the "show mac-address-table" command when trying to look up mac addresses, but how do you find source and destination mac addresses? I can't seem to figure out how to do this with my 2950 switch. And how do you look up which switch is a root switch and which isn't? The Sybex book has very poor coverage of switches.
thanks!
Firstly i know about the "show mac-address-table" command when trying to look up mac addresses, but how do you find source and destination mac addresses? I can't seem to figure out how to do this with my 2950 switch. And how do you look up which switch is a root switch and which isn't? The Sybex book has very poor coverage of switches.
thanks!
Starting my CCNA journey!
Comments
-
Netstudent
Member Posts: 1,693 ■■■□□□□□□□
You can see which switch is root with the show spanning-tree command. You can find the vtp server with the show vtp status command. better luck next time.There is no place like 127.0.0.1 BUT 209.62.5.3 is my 127.0.0.1 away from 127.0.0.1!