nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

Point to Point T1 with no config

mzinz

I have a Point to Point T1, with no config on either end (no ip).

Both ends show the link as up, and can detect the remote end via "sh cdp nei".

Will it actually pass traffic, or does it just show itself as up because it is on layer2?

Find more posts tagged with

SAVE $250 on Your CISCO Boot Camp — Use Code "EXAM26"

Exclusively for TechExams members for Infosec Boot Camps starting before April 30, 2026

View CISCO Boot Camps

Comments

cisco_trooper

mzinz wrote:

I have a Point to Point T1, with no config on either end (no ip).

Both ends show the link as up, and can detect the remote end via "sh cdp nei".

Will it actually pass traffic, or does it just show itself as up because it is on layer2?

Well, you do have layer 2 connectivity or CDP wouldn't work. Being a T1, I'm inclined to think there is not much use for it without layer 3 connectivity. I'm far from an expert on T1s though...

You may be able to use ip unnumbered if you want layer 3 without wasting IP addresses for a point-to-point link....

darkuser

we'll yes you can pass layer two traffic end to end as proved by the sh cdp nei
if you'd like to pass layer3 traffic assign a layer3 address to each end of the link.
(thereby enabling ip on the interface)

then ping each end.
now you have layer3 connectivity voila !!!

Aquabat [banned]

hey mzinz. is ur t1 going straight into wic card from the smartjack. or are you using an external csu