CM Fail back - Not Working.

We are opening a very small new office and our MPLS connection will not be turned up soon enough.

The thought was the put a 2811, 4 pots lines in the 2811, a switch and 4 phones at this site and have the phones go into CM Failback mode.

But the phones don't go in to CM Failback mode.
The phone does grab a DHCP address from the 2811 though.

We have many other sites that CM-Failback works and im using the same config for this router.

What could be causing my issue?
This router has never been connected to our network before.


CM-Failback config


call-manager-fallback
max-conferences 8 gain -6
transfer-system full-consult
ip source-address 172.17.14.1 port 2000
max-ephones 30
max-dn 144 dual-line
voicemail 817347436000
no huntstop
time-zone 5

Comments

  • dtlokeedtlokee Member Posts: 2,378 ■■■■□□□□□□
    have the phones and gateway been registered to the CM at some point in time?
    The only easy day was yesterday!
  • mattsthe2mattsthe2 Member Posts: 304
    negative.

    This is a new temporary network (new LAN IP's), with a new IOS config. The router might have but again, new IOS software and a new config.
    The 4-phones probably have.

    I'm thinking that the fact the router hasnt been registered before with CCM is causing this issue.
    I was thinking about registering the router (at corporate) and then shipping down the equipment and hoping it goes int SRST mode.


    It would only be running for about 3 days while they move offices.
    (Very small office by the way).
Sign In or Register to comment.