nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

SDM on the CCNA

Gauge

As I'm sure you've seen, I'm just sending an avalanche of posts up here because I have my test tomorrow and I'm kind of nervous. I've studied the CLI and other material primarily. I do have the SDM demo on my PC at home and have gone through it when Lammle covers it in the chapters, but I haven't really given it another look. The interface is so intuitive, so I don't see how it could really be difficult to figure out in a simulation.

Should I expect anything more complicated than just basically clicking through the interface and setting up some fairly intuitive, simple configurations?

Find more posts tagged with

SAVE $250 on Your CISCO Boot Camp — Use Code "EXAM26"

Exclusively for TechExams members for Infosec Boot Camps starting before April 30, 2026

View CISCO Boot Camps

Comments

wat08

The SDM is part of the exam objectives for the CCNA so if you're comfortable configuring DHCP, DNS, and ACLs, you'll be fine.

LBC90805

wat08 wrote:

The SDM is part of the exam objectives for the CCNA so if you're comfortable configuring DHCP, DNS, and ACLs, you'll be fine.

And don't forget NAT/PAT

rbutturini

Don't spend too much time on it. SDM is not extensively covered on this exam.