Router problem

Fire Starter

Hi I just installed a newer IOS 12 on a 2620 router.

During the installation i set the spped to 115000 instead of 9600

Now if you log in to the router you can only do so at the newer speed instead of the standard rate of 9,600 baud.

Anyone have a solution, thanks

Fire Starter

By the way, the Configuration register is 0x3922

stnosc

Fire Starter wrote:

Hi I just installed a newer IOS 12 on a 2620 router.

During the installation i set the spped to 115000 instead of 9600

Now if you log in to the router you can only do so at the newer speed instead of the standard rate of 9,600 baud.

Anyone have a solution, thanks

This link should square you away. Make sure you change your configuration register back to 0x2102 when you are finished:
http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008009433b.shtml#speed