Flash errors

jbrad95706

%Error: System flash bank 1 chip 0 unknown, chip id 0x540F (reversed = 0x2AF0)

%Error: System flash initialization failed

...

%Error: System flash bank 1 chip 0 unknown, chip id 0x5000 (reversed = 0xA00 )

%Error: System flash initialization failed

...


I'm going to assume one of the 2x chips is going bad?

Is this just "ram" or is it worse than that?


Thanks for you time!

jbrad95706

Router(boot)#erase flash

System flash directory:
No files in System flash
[0 bytes used, 16777216 available, 16777216 total]

Erase flash device? [confirm]
Are you sure? [yes/no]: yes
Erasing device... eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee ...NOT erased
Router(boot)#


Also, getting this...


Going to assume this will fix me up?

I'm wondering if it's even worth it? I have another 2520 that seems to be fine, and I plan to get another router anyway... Hmmm.

dtlokee

The 2500 has 2 flash modules in it, 1 could be defective or might need to be reseated. If you are going to replace it you could probably just buy 1 module. You can try to figure out which one is bad by removing them one at a time but from the error message it looks like bank 1 is your trouble.

jbrad95706

dtlokee wrote: »

The 2500 has 2 flash modules in it, 1 could be defective or might need to be reseated. If you are going to replace it you could probably just buy 1 module. You can try to figure out which one is bad by removing them one at a time but from the error message it looks like bank 1 is your trouble.

Yea, I tried to reseat them, but no joy. I just picked up the one chip - saves me some cash.


Also, you linked me "Cisco Feature Navigator" for my ios question the other day, and it was a lot of help (Thanks!) for my routers, but I couldn't seem to find my switch on there - it's a WS-C3512-XL-EN.

Am I doing something wrong, or does it no list older than dirt switches hehe.

Thanks again for all your help!