CCNA LAb problem

I did something stupid when practicing password recovery. I was going thru the recovery lab; I brought it up with 0x2142 made my changes. Then booted the router but I forgot to switch it back to 0x2102. So I just did a control-Break it sent me to the rommon prompt. Here were I screwed up I did a rommon1> confreg 0x2120 (instead of 0x2102), then a rommon2> reset. Now I am not getting anything on the console. I confirmed hyperterm and cable are working fine by moving it my switch. Any help with this would greatly appreciated. Thanks

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

tiersten

You changed it to 19200 baud.

hblackb

Thanks that worked. Why does the rate change? Thanks.

tiersten

hblackb wrote: »

Why does the rate change?

You changed the config register. Some of the bits specify the baud rate.

You should double check commands before running them since a mistake could mean you down the only link to a device/site and require a site visit.

aordal

Use of the Configuration Register on All Cisco Routers - Cisco Systems

2120 changes baud. You told it to change.

captobvious

aordal wrote: »

Use of the Configuration Register on All Cisco Routers - Cisco Systems

2120 changes baud. You told it to change.

Doh! I hate when I do that!