Options
PAth COde VIolations
thenjduke
Member Posts: 894 ■■■■□□□□□□
in CCNA & CCENT
I Know this has a issue with timing and i am looking at my works configuration.I had some question on this. We have a office A (HQ) and office b (west) and they are connected through T1. We are getting path code violations on Router b (West)
T1 0/1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info Firmware: 20050620, FPGA: 16, spm_count = 0
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (861 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 24 hours)
25 Line Code Violations, 9938 Path Code Violations,
1 Slip Secs, 0 Fr Loss Secs, 25 Line Err Secs, 25 Degraded Mins,
26 Errored Secs, 0 Bursty Err Secs, 5 Severely Err Secs, 134 Unavail Secs
I notice the clock source is set to line and on ROuter A(HQ) the T1 is set to
Clock Source is Line Independent.
Should this be configure like this?
T1 0/1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info Firmware: 20050620, FPGA: 16, spm_count = 0
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (861 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 24 hours)
25 Line Code Violations, 9938 Path Code Violations,
1 Slip Secs, 0 Fr Loss Secs, 25 Line Err Secs, 25 Degraded Mins,
26 Errored Secs, 0 Bursty Err Secs, 5 Severely Err Secs, 134 Unavail Secs
I notice the clock source is set to line and on ROuter A(HQ) the T1 is set to
Clock Source is Line Independent.
Should this be configure like this?
CCNA, MCP, MCSA, MCSE, MCDST, MCITP Enterprise Administrator, Working towards Networking BS. CCNP is Next.