IOS for 1841

Hey,

I have an 1841 which has an ADSL WIC installed and also a VPN module.

Having trouble finding an IOS that supports both the ADSL WIC and VPN.

Currently got c1841-adventerprisek9-mz.124-25b.bin on there but this does not seem to support the ADSL WIC as i get these errors and the ATM interface does not show up;

CFG-3-CARD_NOT_SUPPORTED: Slot 0: Unknown WAN daughter card, Part# 73-9932-6, HW-Rev 8.0, Board-Rev A0

Router#sh ip int bri
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 unassigned YES NVRAM administratively down down
FastEthernet0/1 192.168.1.4 YES DHCP up up

however this image does support the VPN

Cisco 1841 (revision 7.0) with 234496K/27648K bytes of memory.
Processor board ID FHK12102A30
2 FastEthernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)

The ip_base image supports the ADSL but not the VPN....
Anyone know of an IOS that supports both?
thanks

Find more posts tagged with

SAVE $250 on Your CISCO Boot Camp — Use Code "EXAM26"

Exclusively for TechExams members for Infosec Boot Camps starting before April 30, 2026

View CISCO Boot Camps

Comments

kristianbrown

Hi,

I believe the advipservicesk9-mz series support both. Which train is most stable, im not sure of tho.

rakem

hmmm i loaded up

c1841-advipservicesk9-mz.124-25a

And it does not look like it supports the ATM interface. Got the same error

"CFG-3-CARD_NOT_SUPPORTED: Slot 0: Unknown WAN daughter card,"

Gonna try a spservices one now...

Edit: c1841-adventerprisek9-mz.124-24.T2 Did the trick

kristianbrown

Thats weird as I have used those IOS versions for dsl wan interfaces all the time. When i think about it, I have used it for SHDSL annexB wan interfaces, but that shouldnt be too much difference as far as i know.

tiersten

Support for the ADSL HWIC was only added in 12.4.4T.

tiersten

kristianbrown wrote: »

Thats weird as I have used those IOS versions for dsl wan interfaces all the time. When i think about it, I have used it for SHDSL annexB wan interfaces, but that shouldnt be too much difference as far as i know.

You were using the old ADSL WICs probably.