cme call routing

softestplease

Dear expert...


How do you direct the voice traffic (both: voip and pots) to go thru certain interface, like PRI link?

for example:

RouterA

---

RouterB

---

RouterC

---

| (main link - PRI)

---

| (backup link)

---

|

---

|

---

RouterD

---

RouterE

If RouterA would like to call RouterE, how do you direct the call to using the "main link - PRI link" on RouterB >> RouterD >> RouterE? instead of going to RouterB >> RouterC >> RouterE as RouterC is set only for "backup link" incase if the "main link - PRI link" is down.

Please advice

Thanks in advance

broc

you need to use dial-peers and set the preference command under the main link (default preference is 0 and lower number indicate a preferred link).

softestplease

Hi broc,

Thanks for your reply...
I will try that.. however, on the "session target ipv4" which ip address should I put? Is it RouterD that connected to RouterE IP's ?

Thanks again