STCAPP for FXS Ports

johnwest43

Does anyone have some examples of using STCAPP? I want to create an ephone from an FXS port but I cant find complete documentation?

Thanks for the help

pitviper

I played around with this a bit at one point for funzies – From what I remember, you have to activate the STCAPP service and associate it with a CCM group (CME is fine). Then you put the voice port under CM control via a dial-peer:

dial-peer voice 100 pots
service stcapp
port 0/0/0

Then create the phantom ephone. You can find the dummy MAC address here:

#sh stcapp device summary

Total Devices: 2
Total Calls in Progress: 0
Total Call Legs in Use: 0

Port Device Device Call Dev Directory Dev
Identifier Name State State Type Number Cntl

---

---

---

---

---

---

----
0/0/0 AN260B1DFF80000 IS IDLE ALG 1020 CME
0/0/1 AN260B1DFF80001 IS IDLE ALG 1021 CME

So for voice-port 0/0/0, the dummy MAC address of the ephone would look like this:

ephone 9
device-security-mode none
mac-address 60B1.DFF8.0000
type anl
button 1:20

These 2 links should be enough info:

Using STCAPP to make a FXS port a SCCP phone | UC500.com
FXS and SCCP - how do they get together? | UC500.com

Good luck! If you get stuck post back and I'll try to build a quick config in the lab.

johnwest43

Thanks for the help pit viper. I actually ran accross some of the same info yesterday and got it working late last night. Its a long way to go to get a phone to ring!!

I wonder if you can do somthing similar when using SIP ?