How to install a VG224
nellocon
Member Posts: 25 ■□□□□□□□□□
HI All,
Never installed one of these before and have to do one asap...
I am going to connect it to our core switch with a IP on the interface. Then I need to register this to the call manager similar to a normal gateway. However, what I am confused about is the analog modems that will connect to it.
How will these be contactable from the outside world? DO I assign a PRI from our range to this somehow or what...?
AS you can see I am totally confused about these so I might need to read up more on them...a link to a good document on cisco would possibly help greatly
Thanks all
Never installed one of these before and have to do one asap...
I am going to connect it to our core switch with a IP on the interface. Then I need to register this to the call manager similar to a normal gateway. However, what I am confused about is the analog modems that will connect to it.
How will these be contactable from the outside world? DO I assign a PRI from our range to this somehow or what...?
AS you can see I am totally confused about these so I might need to read up more on them...a link to a good document on cisco would possibly help greatly
Thanks all
Comments
-
jason_lunde
Member Posts: 567
once you get it registered with callmanager you should see the ports listed in cm when you click on the vg224 name. When you click on a port you will be able to give it an extension out of your block. Within each port its going to look like a phone setup within cm...
-
jason_lunde
Member Posts: 567