Has anyone connected CME to Sipgate?
Agent6376
Member Posts: 201
I'm just getting started in the voice world and I'm looking to configure my 2651XM as a sip client with Sipgate. I've searched online and found a few resources, but nothing too concrete. If anyone has been able to configure this and would share a cleaned up config I'd be grateful.
TIA
TIA
Comments
-
VancouverTechie
Member Posts: 18 ■□□□□□□□□□
I'm just getting started in the voice world and I'm looking to configure my 2651XM as a sip client with Sipgate. I've searched online and found a few resources, but nothing too concrete. If anyone has been able to configure this and would share a cleaned up config I'd be grateful.
TIA
I am running CME on a 1751-V and I am connected to flowroute. I know it is not the same but the setup looks comparable. I don't know if this helps or not. I have also tried Asterisk and Trixbox, but was able to get it going through CME with 3 Cisco 7940s and one 7920.
dial-peer voice 1 voip
destination-pattern 1[2-9]..[2-9]......
voice-class codec 1
session protocol sipv2
session target dns:sip.flowroute.com
dtmf-relay sip-notify
!
sip-ua
authentication username ******* password ********************** realm sip.
flowroute.com
no remote-party-id
mwi-server ipv4:192.168.0.51 expires 3600 port 5060 transport tcp unsolicited
registrar dns:sip.flowroute.com expires 3600
!
!
telephony-service
load 7960-7940 P00306000500
load 7920 cmterm_7920.4.0-03-02
max-ephones 10
max-dn 50
ip source-address 192.168.0.222 port 2000
max-redirect 8