Check Clock Rate on DCE device?

mguy

Where would I go or what command should I use to check the clock rate on a serial line on a DCE device?

Thank you!

Roguetadhg

in a lab environment, on a router, it's "show controllers".

Output in GNS3:
PAS unit 0, subunit 0, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x6402878C, ds = 0x64029854, ssb=0x64029C18
Clock mux=0x0, ucmd_ctrl=0x0, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=down DSR=down DTR=up RTS=up CTS=down
line state: down
cable type : V.11 (X.21) DCE cable, received clockrate 2015232


base0 registers=0x3C000000, base1 registers=0x3C002000
mxt_ds=0x646BA730, rx ring entries=78, tx ring entries=128
rxring=0x7B18760, rxr shadow=0x64030274, rx_head=0
txring=0x7B18A20, txr shadow=0x64030650, tx_head=0, tx_tail=0, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, ****_err= 0, bogus=0, mxt_flags=0x0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=0, mxt_flush_count=1
rx_int_count=0, tx_int_count=2