Tuning EIGRP metrics
jude56g
Member Posts: 107 ■■■□□□□□□□
in CCNA & CCENT
The book I'm reading states that serial interfaces should be configured with the bandwidth command to ensure accurate calculation of EIGRP metrics; it says it should match the speed of the interface.
I'm curious, if the link in question were a 768k circuit over a T1 interface if the bandwidth should be configured as 1540000 (based on the interface) or 768000 (based on the link speed).
I'm curious, if the link in question were a 768k circuit over a T1 interface if the bandwidth should be configured as 1540000 (based on the interface) or 768000 (based on the link speed).
Comments
-
networker050184
Mod Posts: 11,962 Mod
Well, if you want an accurate calculation wouldn't you want to put the accurate bandwidth?
Also note that the bandwidth command is in Kbps.An expert is a man who has made all the mistakes which can be made.