So im trying to figure out why this is:
I'm trying to shorten the length of the output from a page full of extras to just what im looking for. I can reference the bandwidth, that I just set. However, i'm unable to referece the word "bw" or "mtu" for the pipe?
[B][COLOR=#b22222]R2#show int s1/0 | s bw[/COLOR]
R2#show int s1/0 | s 64[/B]
MTU 1500 bytes, BW 64 Kbit/sec, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 48 kilobits/sec
[B][COLOR=#b22222]R2#show int s1/0 | s bw
R2#show int s1/0 | b bw
R2#show int s1/0 | b mtu[/COLOR]
R2#show int s1/0[/B]
Serial1/0 is up, line protocol is up
Hardware is M4T
Internet address is 10.1.200.2/24
MTU 1500 bytes, BW 64 Kbit/sec, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive set (10 sec)
Restart-Delay is 0 secs
Last input 00:00:01, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
...
Is there a set of defining rules or regulations as to make the pipe command show what I need, instead of what I already know?
