Windows 7 ImageX

Lee H

Hi

I have made a WIM using ImageX but cannot get it to load, I am certain its to do with the System Reserved partition because ImageX will only capture 1 partition

I manually created 100MB drive with no letter assigned, then the remainder is for C which I apply my WIM image to

Then when I boot laptop it starts to PXE boot so its not even starting to load Windows

Any help would be great

Thanks

Lee

kriscamaro68

You need to capture the d: drive with imagex and then apply it to the d: drive on the newly formatted drive. C: gets setup as the system reserved. After you apply the image using imagex make sure to run the bcdedit commands to point to the boot drive.