Transcoding issue?

unknown

I just about have my cme pbx setup. I can call to my AA from the outside. The phone pauses then hangs up once I press the extension or for example 2 for sales. I assume its a transcoding issue. I have voice class codec 1 on all the dial peers except for CUE dial peer.

voice class codec 1
codec preference 1 g711ulaw
codec preference 2 g729r8

I looked online and found a config and what mac should I reference under associate profile register? How does my config look for transcoding?

My ip source-address is 1.1.1.1 -->loopback
cme router is 10.10.10.1 on vlan 10

voice-card 0
dsp services dspfarm
!
sccp local Vlan10
sccp ccm 10.10.10.1 identifier 1
sccp
!
dspfarm profile 1 transcode
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
maximum sessions 4
associate application SCCP
!
sccp ccm group 1
associate ccm 1 priority 1
associate profile 1 register MTP123456782012
keepalive retries 5
switchover method immediate
switchback method immediate
switchback interval 15
!
telephony-service
sdspfarm units 1
sdspfarm transcode sessions 4
sdspfarm tag 1 MTP123456782012
ip source-address 1.1.1.1 port 2000

dial-peer voice 11 voip
description **CUE Auto Attendant**
translation-profile outgoing PSTN_CallForwarding
destination-pattern 2003
b2bua
session protocol sipv2
session target ipv4:10.10.10.5
dtmf-relay sip-notify
no vad