ecp /epp

vicbersong

HI giyz, pls can someone tell me which one is the fastest off the parrallel port technology, ecp or epp, and which one has the highest throughput. Thanks for ur help so far guyz!

Plantwiz

You may find this of some interest
http://computer.howstuffworks.com/parallel-port.htm

from the above link
SPP/EPP/ECP
The original specification for parallel ports was unidirectional, meaning that data only traveled in one direction for each pin. With the introduction of the PS/2 in 1987, IBM offered a new bidirectional parallel port design. This mode is commonly known as Standard Parallel Port (SPP) and has completely replaced the original design. Bidirectional communication allows each device to receive data as well as transmit it. Many devices use the eight pins (2 through 9) originally designated for data. Using the same eight pins limits communication to half-duplex, meaning that information can only travel in one direction at a time. But pins 18 through 25, originally just used as grounds, can be used as data pins also. This allows for full-duplex (both directions at the same time) communication.



Enhanced Parallel Port (EPP) was created by Intel, Xircom and Zenith in 1991. EPP allows for much more data, 500 kilobytes to 2 megabytes, to be transferred each second. It was targeted specifically for non-printer devices that would attach to the parallel port, particularly storage devices that needed the highest possible transfer rate.




Close on the heels of the introduction of EPP, Microsoft and Hewlett Packard jointly announced a specification called Extended Capabilities Port (ECP) in 1992. While EPP was geared toward other devices, ECP was designed to provide improved speed and functionality for printers.




In 1994, the IEEE 1284 standard was released. It included the two specifications for parallel port devices, EPP and ECP. In order for them to work, both the operating system and the device must support the required specification. This is seldom a problem today since most computers support SPP, ECP and EPP and will detect which mode needs to be used, depending on the attached device. If you need to manually select a mode, you can do so through the BIOS on most computers.

http://computer.howstuffworks.com/framed.htm?parent=parallel-port.htm&url=http://www.whatis.com/definition/0,289893,sid9_gci212069,00.html