Mimicking a Call from a Remote Site
control
Member Posts: 309
Is there a way on CUCM to test dial from it, if it's installed on a remote site?
In CME installation, I can telnet to the remote router and run a csim start xxxx which would then show me results of any debugs I was running.
If I wanted to connect to a remote CUCM installation, is there a similar action? I want to test dialing certain extensions/numbers from a remote site which has CUCM installed, and see the results from debugs.
Thanks
In CME installation, I can telnet to the remote router and run a csim start xxxx which would then show me results of any debugs I was running.
If I wanted to connect to a remote CUCM installation, is there a similar action? I want to test dialing certain extensions/numbers from a remote site which has CUCM installed, and see the results from debugs.
Thanks
Comments
-
pitviper Member Posts: 1,376 ■■■■■■■□□□Try the Dialed Number Analyzer (DNA) under Unified Serviceability -> Tools.CCNP:Collaboration, CCNP:R&S, CCNA:S, CCNA:V, CCNA, CCENT