ASA 5510 - Temperature commands

dredlorddredlord Member Posts: 172
in CCNP Security
Is there a command one could use to check the temperature of a ASA 5510 as I can't seem to find the command and show environment is not available
· Share on FacebookShare on Twitter

Comments

  • RouteMyPacketRouteMyPacket Member Posts: 1,104
    ASA 5580 has the sh environment command, I am unaware of any such command for the 5510. You need to monitor the ASA via SNMP and make sure your monitoring system has the "CISCO-FIREWALL-MIB"
    Modularity and Design Simplicity:

    Think of the 2:00 a.m. test—if you were awakened in the
    middle of the night because of a network problem and had to figure out the
    traffic flows in your network while you were half asleep, could you do it?
    · Share on FacebookShare on Twitter
Sign In or Register to comment.