Packet Tracer VRF

Alabama

Hi Everyone,

I am trying to simulate a network with Cisco Packet Tracer and I need to define different VRFs to isolate different kinds of traffic. So far, I have not been able to create VRF on Routers or layer 3 switches. Whenever I run the command to create vrf I get an error:

Router(config)#ip vrf
^
% Invalid input detected at '^' marker.

Does packet tracer support VRF?

Thank you guys!

aftereffector

Based on your command line output above, I would say the answer is no. Unfortunately PT isn't a 100% solution for labs.