Can't ping interface

I'm getting started with my home lab setup, and already am running into snags.

I have a workstation with 10.0.0.10/24 assigned. It is connected to fa0/0 on a 2960 router with 10.0.0.1/24. On Fa0/1 I have 172.16.0.1/30. Both interfaces are up/up. From the workstation, I can ping 10.0.0.1, but not 172.16.0.1.

What is wrong?

Find more posts tagged with

Comments

dontstop

What's the default gateway of the PC?

2960 Router? The only 2960 that I know of is a 24/48 ports 2 switch that has some basic Layer 3 routing capabilities. What's the exact model of your 2960 "show version" and can you paste the "show run"?

Gomjabber

Hey thanks for the reply dontstop.

The router is an 1841, my bad. I do have 2 Catalyst 2960 series PD switches though. I haven't been using them too much yet, as most of my labs have been using the 1841's.

Default gateway is 10.0.0.1.

When I was confirming my default gateway I decided I should turn off my wifi and afterwards, boom I could ping fa0/1.

Hopefully I'll get better as time goes on.

Thanks.

DCD

Need a "Show IP interface Brief" and "Show IP Route" and the PC IP configuration. The PC is the mostly likely issue