Autoqos interoperability with Mitel?

Will the Autoqos commands work, even when Cisco gear isn't being used (Mitel, specifically).

I know that Mitel will use RTP for its voice traffic, but I'm not so sure about signaling/control protocols.

Anyone know about this?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

dtlokee

Which part of AutoQoS? If applied to an access port it will use CDP to make sure there is a phone connected and then apply the corect port trust settings. You may be better off hardcoding the settings you want on the interface (assuming the phone can do the marking.)

mzinz

dtlokee wrote:

Which part of AutoQoS? If applied to an access port it will use CDP to make sure there is a phone connected and then apply the corect port trust settings. You may be better off hardcoding the settings you want on the interface (assuming the phone can do the marking.)

I'm trying to set up the simplest QoS possible -- Just tagging data as it goes out. What would be the best way to accomplish that?